Brother IntelliFax-4100E High Speed Business-Class Laser Fax

Buy Brother IntelliFax-4100E High Speed Business-Class Laser Fax


The Brother IntelliFax-4100e High Speed Business-Class Laser Fax is designed to meet the needs of any business with its high-capacity paper tray, automatic document feeder, ultra-fast fax speeds, and even high-quality copy capabilities. This fax machine can even operate as a black and white printer with speeds of up to 15 pages per minute (ppm) by using the built-in USB and parallel interfaces.

• Black-and-white laser fax machine also copies and prints
• Fax transmission speeds up to 3 seconds per page
• 600 x 600 DPI resolution for faxes, copies, and prints
• Auto-dial up to 132 numbers
• 250-Sheet paper tray and 30-sheet automatic document feeder

This Fax Machines give to us some advantages, like this :
1. Speedy
We just ordered our 2nd machine for our office. It is speedy, efficient, and easy to use. It has a large capacity memory for scanning - an important component for us since we routinely fax and receive documents up to 100 pages. It took just a few minutes to set up and operate, a plus for a busy office of so-so tech savy folks.

2. Reliable and Easy to Use
I have bought 2 of these over 3 years, one for my office and one for my better half. My new one has already proved itself invaluable. Easy to use, relatively inexpensive replacement cartridges and good quality print quality.

Mainly I like that it is reliable and very easy to setup with very few paper jams.

Need more appointment... ?
How to configure Brother IntelliFax-4100E for VoIP
Here is the procedure to configure Brother 4100e fax machines to work with faxing over VoIP.

Enter Maintenance Mode:

1. Unplug power from rear of fax machine, hold the Menu button while plugging power back in. Continue to hold the Menu button until "Maintenance" appears in the LCD window.
2. There are no helps for the Maintenance mode. Follow parameter change procedures to the letter.

Changing Baud Rate from Automatic to 9600:

1. Enter 10 (one, zero). This will bring up WSW00 on the LCD window.
2. Change the 00 to 19. If the baud rate is set to automatic, the numbers that appear will be 11100010.
3. Change the 11100010 to 01100010. This sets the baud rate to 9600.
4. Press the "Set" button just below the LCD window.
5. Press "Stop".
6. Enter 99. This will exit Maintenance mode and make the fax ready to use again.

Changing the Error Correction Mode (ECM):

1. Enter Maintenance Mode (see...
More information by clicking here.